deluxerefa.blogg.se - Wp 10 wavemaker

#Wp 10 wavemaker install
#Wp 10 wavemaker manual

To reduce the risk of fire or electric shock, do not expose the controller unit to rain, moisture, dripping or splashing Operation of pump.

The controller unit should be situated away from heat sources such as radiators, and do not expose to excessive heat such as sunshine, tire or the like.

#Wp 10 wavemaker manual

Always follow the operation instructions set forth in this manual when using this controller unit.

Magnet holder clamp up to a glass thickness of I 5mm (1/2″) or need to buy extra magnet holder set if glass thicker than 15ram.

Clean the glass before assembly the pump:.

#Wp 10 wavemaker install

Please reference the install instruction photos as below:

Do not place your fingers between the magnet mount set as there is a strong magnetism. Install the wet side magnet firstly, then move the dry side magnet to fix the pump. Please use the magnet mount set to locate the cross flow wave pump where you intend to install.You must first connect the cable from the Controller to the pump then connect the cable from the power supply to the controller. The cross-flow pump has a built in safety mechanism.Accesses: controller, adaptor, power cable, cross-flow pump.Suitable for most sizes of the fish tank, the tank thickness of less than 15mm would be better.Jam° disci:intim% and will not be liable for damage to any aquarium or their surroundings, water damage, or any other consequential damages resulting from wave generation. Please also check to assure you’re your aquarium stand or furniture is properly leveled, which will help reduce the additional tress resulting from wave generation. Please consult with your aquarium manufacturer to determine if the aquarium construction is adequate to withstand the additional stress generated by the pulses and waves motion. Not all aquariums are able or designed to withstand this stress and failure of the glass/acrylic and/or joints could result.

Cross flow pump can place additional stress on the aquarium glass/acrylic and its joints. Do not put the mental and magnet mount set together Magnet mount set may damage the magnetic storage device such as USB, pacemaker, credit card, do not put these device together with magnet holder set 5. Do not put your rulers between the magnet mounts. Handle the magnet mount with their proper handle, and do not bring the both side together directly. Warning: Please put the magnet mount out of reach of children! For indoor use only and please use correct accesses.Please locate the power cable in suitable place and avoid any damage, don’t touch cable or plug when hand is wet.But please use the correct type of power supply/cable and do not disassembly or damage the plug and power supply liebao Cross- Flow Wave pump can be used in large range of voltage input (AC 100-240V 50/60Hz) allows to operate in various power system and prevent the impact on waves.Be sure to read and save this manual for future reference failure to follow the instructions and warnings in this manual may result in pump’s damage and/or serious injury. Introduction: Jerboa’s Cross- Flow Wave pumps are carefully inspected and tested to ensure both safety and operating performance.